Page 1 of 1
print with hidden lines
Posted: Fri May 27, 2005 1:12 am
by Daniel
I have a problem when try to print a drawing with hidden lines. Is possible make this work?
I tried Icad 5.1 & Icad 6 trial but can't.
Posted: Fri May 27, 2005 3:22 pm
by CW
Works for me, no problem. Give a few more details. What's happening when you try?
Posted: Fri May 27, 2005 4:00 pm
by Daniel
-I made a 3d home
-I use hide command
At print preview, the image is stretched.
If don't use the hide command for firs, the image in print preview is normal, but with all the lines.
Thanks
Posted: Sat May 28, 2005 9:54 pm
by CW
unfortunately, I gave a response without doing enough testing. As I only do 2D in Icad (all 3D is done in another application), I did not look into the problem sufficiently before responding. You are right, there is visable distortion when printing in hidden line mode. I have not been able to find a way around it. Unless someone can say otherwise, I will have to count it as a bug.