Free technical support forum for CMS IntelliCAD and ERP MRP Software
https://forums.intellicadms.com/
It looks like IntelliCAD is having trouble with the midpoint snap using Shift. Make sure OSNAP is on and Midpoint is checked. Some versions don’t support Shift to select midpoints, so try hovering over the midpoint directly or entering coordinates manually. Restarting IntelliCAD or resetting settings can also help.UGMENTALCASE wrote: ↑Wed Sep 17, 2025 4:10 pmI'm trying to use the move command and select mid point using 'shift'. I get the error as shown attached. Latest version installed. Any ideas please?
Untitled.jpg Infinite Craft Game
Are you using SHIFT+RIGHT CLICK to load the snaps menu?UGMENTALCASE wrote: ↑Wed Sep 17, 2025 4:10 pmI'm trying to use the move command and select mid point using 'shift'. I get the error as shown attached. Latest version installed. Any ideas please?
Untitled.jpg
The same problem!sln8458 wrote: ↑Wed Dec 10, 2025 1:34 amAre you using SHIFT+RIGHT CLICK to load the snaps menu?UGMENTALCASE wrote: ↑Wed Sep 17, 2025 4:10 pmI'm trying to use the move command and select mid point using 'shift'. I get the error as shown attached. Latest version installed. Any ideas please?
Untitled.jpg
Icad 14.1 has been released and is a FREE upgrade. Try this and see if the error persists.Beatricelly wrote: ↑Tue Jan 06, 2026 4:30 amThe same problem!sln8458 wrote: ↑Wed Dec 10, 2025 1:34 amAre you using SHIFT+RIGHT CLICK to load the snaps menu?UGMENTALCASE wrote: ↑Wed Sep 17, 2025 4:10 pmI'm trying to use the move command and select mid point using 'shift'. I get the error as shown attached. Latest version installed. Any ideas please?
Untitled.jpg