face extude parameters
Posted: Fri Nov 07, 2014 1:48 pm
by mark pigott
when i use an extrude and type in angle 22.5, the command line reports back 23. Is there a setting I am missing?
Re: face extude parameters
Posted: Fri Nov 07, 2014 2:51 pm
by slit_ok
mark pigott wrote:when i use an extrude and type in angle 22.5, the command line reports back 23. Is there a setting I am missing?
can use the command _units?
Re: face extude parameters
Posted: Fri Nov 07, 2014 3:01 pm
by mark pigott
you are correct...all fixed!
slit_ok wrote:mark pigott wrote:when i use an extrude and type in angle 22.5, the command line reports back 23. Is there a setting I am missing?
can use the command _units?