face extude parameters
#1when i use an extrude and type in angle 22.5, the command line reports back 23. Is there a setting I am missing?
Re: face extude parameters
#2mark pigott wrote:when i use an extrude and type in angle 22.5, the command line reports back 23. Is there a setting I am missing?
can use the command _units?
Re: face extude parameters
#3you are correct...all fixed!
slit_ok wrote:mark pigott wrote:when i use an extrude and type in angle 22.5, the command line reports back 23. Is there a setting I am missing?
can use the command _units?