CAD Software Forum

Posted: **Mon Mar 07, 2005 4:42 pm**

Can anyone tell me if it is possible to perform simple animation in Intellicad 2001 (something like a door opened, door closed elevation)without being some kind of a LSP-whiz?
Doc

Posted: **Mon Mar 07, 2005 5:49 pm**

I would make a slide (mslide) of each instance or drawing, then use vslide to view them.
Make a script... something like Vslide>1>delay(time between pictures)>Vslide>2.
Run the script to view the animation. You can include running the script in the script to make it loop continuously.

Posted: **Tue Mar 08, 2005 3:19 pm**

Thanks! That sounds a whole lot easier than what I had in mind.