CAD Software Forum

Posted: **Wed Aug 31, 2005 5:24 pm**

The GetPoint method will not snap to anything if you provide a "relative" point arguement for rubber banding.

eg: GetPoint(varPoint1, "Pick Next Point")

Any workarounds? Will the GetPoint method ever be repaired? It seems to be biffed in every version of ICAD.

Posted: **Thu Sep 01, 2005 3:47 pm**

gsprink,

The code below will snap to the end point.

Set SnapSet = IntelliCAD.ActiveDocument.Utility.EntitySnap(IntelliCAD.ActiveDocument.Utility.GetPoint(, "Select Point"), vicOsnapEnd)

------------------
Regards
John Finlay

Posted: **Tue Sep 06, 2005 9:39 am**

Can this reflect the current esnap mode rather than a particular snapmode?