move, copy problem
Posted: Fri Mar 18, 2005 8:12 am
I place this in general topic, but now I try here:
when I want move or copy object like in ACAD2000 - its impossible:
I want select for example LINE, then in ORTHO mode pick point anywhere in workspace, than move mouse in side of moving, write only number of moving (without @...) for examle 5000.... and enter...
now is possible move or copy only from existing poin to existing point (in object) or with direct co-ordinates (@5000,0) - this is very slow !!!
knows nobody some lisp routine, to repair this?
when I want move or copy object like in ACAD2000 - its impossible:
I want select for example LINE, then in ORTHO mode pick point anywhere in workspace, than move mouse in side of moving, write only number of moving (without @...) for examle 5000.... and enter...
now is possible move or copy only from existing poin to existing point (in object) or with direct co-ordinates (@5000,0) - this is very slow !!!
knows nobody some lisp routine, to repair this?