Page 1 of 1
Selecting multiple entities
Posted: Mon Aug 01, 2005 5:13 am
by MROCK
Some times I have two block at the same position or overlaping. In former versions of Icad, only one of them was selected when clicking on the block. In Icad6 all blocks are selected with only one click.
Is there any system variable to change this? ANy other configuration?
------------------
Michael Röck
Posted: Mon Aug 01, 2005 7:49 am
by John Finlay
MROCK,
I have just tried this with two blocks with the same name and each can be selected independently in IntelliCAD 6.
I am using Support ID 6.0.12.1 version.
------------------
Regards
John Finlay
Posted: Tue Aug 02, 2005 10:36 am
by MROCK
Sorry, it seems I did not make myself clear:
I have two (or more) blocks in a drawing. I try to delete (or copy or move) one of them, selecting the block by clicking directly on it (no selection window).
If inside the Entity selection box is part of another block, both blocks will be selected at once. In Icad5 only one of them has been selected (probably depending on draworder).
------------------
Michael Röck