Page 1 of 1
File open.
Posted: Mon May 30, 2005 6:30 pm
by CW
When I go to open a new file, the files of typ defaults to DWT. This is rather annoying. Just me or is this usual? BTW, Icad 6.
[This message has been edited by CW (edited 05-30-2005).]
Posted: Tue May 31, 2005 11:12 am
by LenR
DWT is the template file that Intellicad uses to configure your new drawing. When you save the drawing is should default to DWG.
Posted: Tue May 31, 2005 7:06 pm
by CW
I should have worded that differently. I meant opening an existing drawing. File, open... It always comes up looking for a dwt, I have to manually change it to dwg.