Direct modeling (push/pull) VS Parametric modeling
Posted: Mon Jul 14, 2025 11:13 am
Direct modeling (push/pull) such as SketchUP & parametric modeling are two distinct approaches in CAD software. Direct modeling allows for intuitive, freeform manipulation of geometry, while parametric modeling mostly uses parameters such as input measurements to define & make changes to alter a model.
Therefore, can these two approaches co-exist within one software & does CMS IntelliCAD have this in some form or a potential addition for the not too distant future ?
Therefore, can these two approaches co-exist within one software & does CMS IntelliCAD have this in some form or a potential addition for the not too distant future ?