CAD Software Forum

Free technical support forum for CMS IntelliCAD and ERP MRP Software
https://forums.intellicadms.com/

Prespective seems wrong

https://forums.intellicadms.com/viewtopic.php?t=354

Page 1 of 1

Prespective seems wrong

Posted: Fri Apr 02, 2004 8:55 am
by jt27278
When I render 3D objects the prespective seems wrong. For example when viewing a cylinder from an angle, the end which is closer appears smaller than the end that is further away. What's going on?

Posted: Fri Apr 02, 2004 11:31 am
by John Finlay
jt27278,

Type in Viewpoint at the command prompt then PE (PErspective Mode) and select OFF.

------------------
Regards
John Finlay
All times are UTC-06:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited