Just activated my licensee for the 1st time and after I open a new drawing and I go to insert a foundation wall. I get the error shown below. Is there something I need to turn on to activate it?

Hi,
Which version of the IntelliCAD do you use now?
As I know, only the "IntelliCAD Premium Edition Plus" supports AEC entities such as walls, windows, doors, openings, stairs, railings & slabs, etc.
Regards,

I did buy the CMS IntelliCad PE 11.1 Plus.

Please verify that the system variable "AECOBJECTS" is set to 1.

Hi Quan,

I have this same problem, noticed when I tried to load _steel, I get the same error.
I have PE+ (11.1.435.145443.PE+).
I'm hoping that release 12.0 solves this.

SteveN
PS
I have reported the issue some time back [ID: 4709]

Hi Stephen,
I have the PE+ (11.1.435) too.
the AEC works as they are on my PC.
Please try to reinstall it again.
Regards.

I did that, about 5 times, CCleaner between each one.
Still no change!!

QuanNguyen wrote: ↑

Tue Nov 14, 2023 6:10 pm

Please verify that the system variable "AECOBJECTS" is set to 1.

AECOBJECTS was showing off and I turned it on and no difference. Still not recognizing the commands.

BulkHT wrote: ↑

Wed Nov 15, 2023 9:49 am

QuanNguyen wrote: ↑

Tue Nov 14, 2023 6:10 pm

Please verify that the system variable "AECOBJECTS" is set to 1.

AECOBJECTS was showing off and I turned it on and no difference. Still not recognizing the commands.

Do you get the dropdown menus as per Quan?
or like mine?

SteveN

sln8458 wrote: ↑

Wed Nov 15, 2023 10:54 am

Do you get the dropdown menus as per Quan?
or like mine?

SteveN

I get the same drop down menu as Quan but none work.

UPDATE!!!!
I now have it working. I uninstalled the program and reinstalled it with "RUN AS ADMINSTRATOR" and now it is working. I may not have originally installed it as administrator.