Check Valves .
I have progressed the first valve selection, Plain to the point of inserting the completed valve. The code behind this works fine as I step through when checking, but when I try this addition in normal use it sometimes works and sometimes doesn't.
I get this error:
Command: _filletedge
Current settings: mode = TRIM, radius = 3.9000
Select an edge: [Chain/Loop/Radius]: R
Fillet radius <3.9000>: 3.90000
Select an edge: [Chain/Loop/Radius]: 357.5000,0,0
Select an edge: [Chain/Loop/Radius]:
Press Enter to accept the fillet or [Radius]:
Command:
Command: _filletedge
Current settings: mode = TRIM, radius = 3.9000
Select an edge: [Chain/Loop/Radius]: R
Fillet radius <3.9000>: 3.90000
Select an edge: [Chain/Loop/Radius]: 357.5000,0,222.0000
Select an edge: [Chain/Loop/Radius]:
Press Enter to accept the fillet or [Radius]:
Modeling Operation Error:
blends too complex to reorder.
Unable to fillet the 3dSolid.
error: Function cancelled
Command:
Command: '_PMTHIST
Here is the code (lines 9571/9572 in the attaced file):
Code: Select all
(command "_filletedge" "R" EXRAD# (strcat (rtos VRAD#) ",0,0" ) "" "" "")
(command "_filletedge" "R" EXRAD# (strcat (rtos VRAD#) ",0," (rtos FTF#)) "" "" "")
Any thoughts pls?