Page 1 of 1

Strange snap settings behaviour.

Posted: Wed Jan 25, 2023 9:26 am
by Zsolt007
Hi, I installed and use ver. 11.1.
Earlier when I drew e.g. a line and chose "Settings..." from shift+mouse right click menu, the snap settings window opened up and I could turn on or off any of the snap settings. I used this when I wanted to turn on more than one new snap. For example I could turn on the Endpoint and Midpoint.
before.png
before.png (44.29 KiB) Viewed 2374 times
Now in 11.1 the snap settings window does not open up (during a command when I choose Settings... from shift+mouse right click menu), I can only choose snap options in the command bar, and the worst is that if I choose one snap option there, IntelliCAD turns off all the other snaps permanently.
after.png
after.png (8.53 KiB) Viewed 2374 times
Can previous behaviour be restored somehow? (Maybe I've done something wrong?)
Thanks for any advice.

Re: Strange snap settings behaviour.

Posted: Wed Jan 25, 2023 10:21 am
by sln8458
Check your system variable FILEDIA.
This should be set to 1

Re: Strange snap settings behaviour.

Posted: Wed Jan 25, 2023 11:06 am
by Zsolt007
Thanks for the idea. I checked that and it is 1 as it should be by default.
So did this problem appear only for me?

Re: Strange snap settings behaviour.

Posted: Thu Jan 26, 2023 5:49 am
by Zsolt007
In the meantime I did a clear reinstall (I mean without transferring any of my old settings from 11.0) and unfortunately the snap settings window still does not open during command. I hope it will be fixed soon.

Re: Strange snap settings behaviour.

Posted: Fri Jan 27, 2023 4:52 am
by sln8458
It works on my installation (Icad 11.1 PE+):
Image
.

Sellecting Settings does open the dialog

SteveN

Re: Strange snap settings behaviour.

Posted: Fri Jan 27, 2023 12:14 pm
by Zsolt007
Hi Steven, does it open during a command? For example when you draw a line? When no command is running the dialog opens for me too.
Zsolt

Re: Strange snap settings behaviour.

Posted: Fri Jan 27, 2023 2:11 pm
by sln8458
When drawing a line:
Yes it opens, but when you select 'settings' it defaults to the command line rather than open the settings dialog.

However both 10.1 and 11.0 open the dialog and allow you to make changes.

Seems to be a bug, suggest you send in a feedback form.(in HELP)

SteveN

Re: Strange snap settings behaviour.

Posted: Fri Jan 27, 2023 2:59 pm
by Zsolt007
Hi Steven, thank you for your confirmation. I am going to report this bug because the snap dialog is important during editing.
Zsolt