Page 1 of 1

Revolve command

Posted: Fri Feb 11, 2022 4:20 am
by sln8458
The latest update appears to have changed the Revolve command.

Where I previously could revolve a closed polyline (rectangle) entity about an axis through the centerline of 2 parallel sides, through 180 degs.
This is no longer allowed!!

Anyone got any suggestions?
I'm trying to actually create a SOLID piping end cap via lisp, but as this command has changed my lisp no longer works!!

Steve

Re: Revolve command

Posted: Wed Feb 16, 2022 7:25 am
by InGeomatics
I had to go back to the previous update because some of my core functions in Lisp also stopped working. And due to the lack of resources to debug a Lisp function, it is very difficult to discover the exact location of the error. Therefore, I am waiting for the next update to see if the problem is resolved.
This situation happens far too often, so be prepared. I have the habit of saving the previous version in a separate folder, in case this happens.