CAD Software Forum

Hi,
Using LT 4 Win XP
I appear to have lost the fillet function?
What happens is this....
I try to fillet two angled lines (say at 45,
eave of roof, in same plane), pick the 1st
line which works ok, pick the second line
which returns me back to the command prompt
but nothing happens?
Have also tried chamfer same thing?
Please advise? Is this a possible bug?
Thank you in advance.
Eric.

PS. Worked fine up to a couple of days ago??



[This message has been edited by ERIC (edited 08-14-2003).]

Did you check if they are in fact in the same plane? If not, you can use the FLATTEN command to restore the Z-value(s).

Thank you for comeback on this.
Yes I did check for same plane it is correct?
Regards,
ERIC

Is one or both of the enitites a polyline?

If so the fillet command will not work on these.

ssc

Thanxs for the comeback,
Yes their both regular lines on the same plane???
Got me beat???

ERIC