dimension ticks
Posted: Mon Apr 07, 2003 12:21 am
by rolando
Why is it that when i dimension a short distance say 2" vertically, the dimension tick is opposite in direction to that when i dimension a longer dimension say 10'-0 .Please reply to this e-mail asap.
Posted: Tue Apr 08, 2003 1:23 pm
by John Finlay
I also noticed this as well and it only occurs when the dimension distance is small. It leaves the appearance of an "X" instead of a "/" when using continuing dimensions.
I think this occurs when using previous ICAD drawings with an updated version of ICAD.
When I tested new versions of ICAD with new layouts this problem didn't appear.
I would say it may come from settings in the dimensioning conflicting with the openDWG's specs.
------------------
Regards
John Finlay