Customize UI - Not Saving After Hitting Apply, Resets
Posted: Wed May 19, 2021 10:06 am
Question; I have a third party app that is installed, it uses a netload command then automatically loads each time afterwards. There is a ribbon and a couple of toolbars that open when I launch IntelliCAD. I prefer not to load the toolbars so I went into customize UI and selected Hide on each of them, hit apply and close the customize UI menu. When I close and re-open IntelliCAD the toolbars are back.
Cannot figure out how to disable them or dock them, there is a delete option but I may want them so prefer just not to load them.
I also tried to disable all instances and save but it always resets to the default.
Any thoughts or ideas?
Cannot figure out how to disable them or dock them, there is a delete option but I may want them so prefer just not to load them.
I also tried to disable all instances and save but it always resets to the default.
Any thoughts or ideas?