Steel Section Data base
#1hi, is there a way to use US nomenclature for the Steel Sections, instead of the International Nomenclature that comes by default?.
Moderator: CMS Inc
Thank for your experimentation, Steve,sln8458 wrote: ..........
All should now display Imperial measurements.
NOTE: This setting does NOT appear to be saved, so you will need to repeat each time you open the Steel dialogue.
...
I have just double checked, closing Icad between tests and the setting is NOT saved.QuanNguyen wrote: ↑Tue Oct 13, 2020 7:44 amThank for your experimentation, Steve,sln8458 wrote: ..........
All should now display Imperial measurements.
NOTE: This setting does NOT appear to be saved, so you will need to repeat each time you open the Steel dialogue.
...
But on my side, this setting already saved, it opens the last dialogue setting.
Regards,