Page 1 of 1
list of command options over the drawing area
Posted: Thu Oct 08, 2009 8:44 pm
by kcgirl
how do I stop the list of command options from popping up every time I type a command on the command line?
Posted: Fri Oct 09, 2009 2:25 am
by JCAMPOS
Hi kcgirl,
Please, go to the Options dialog box (Tools -> Options...) and, in the "Display" tab, uncheck the "Display prompt boxes" option under the "Menus" section.
Thank you,
JCAMPOS
Toggle Entity Snaps
Posted: Fri Oct 09, 2009 9:42 am
by kcgirl
Is there a way to toggle the entity snaps off and on without actually resetting them each time. I am used to using F3 for this but it does not seem to work with IntelliCad.
Posted: Fri Oct 09, 2009 10:21 am
by JCAMPOS
kcgirl,
Go to the Customize dialog box and, in the "Keyboard" tab, search "F3" in the "Defined keys" list. Then type '_ESNAP;_T in the "Command" textbox (at the bottom) and close the dialog. Then F3 will do it.
If you can't find "F3" in the Defined Keys, click the "New" button to create a Key for F3 with the above command.
Hope this helps.
Best regards,
JCAMPOS
Posted: Fri Oct 09, 2009 11:42 am
by kcgirl
It is already set as you suggested. That will turn the pre-set snaps on OK, but when I hit F3 again it does not turn them off. That is what I am looking for if possible. Something that does both.