CAD Software Forum

Hi gang, got a question for the pros on here, I just downloaded CMS Icad 6.6 pro, demo (not sure if I want to buy it until I can fix this problem)
I was just trying out the software, I drew a box, with a couple of circles on it.
Much to my dismay the circles don't appear round, dimensionally they check out ok X,Y, but they aren't round in appearance. My guess is my wide screen monitor is distorting them, is there a way to compensate for this, in a setting change?
THX Ryan

Are your circles smooth flattened circles (ellipses), or many sided polygons? If the polygons, try a regen, or redraw. If flattened circles, can't help, never had that issue, and that goes back to Acad 2.17, and I usually run some higher end graphics card

elipses, not a big deal I am sure they will print round