Page 1 of 1
Shift + Right Clicking
Posted: Fri Aug 17, 2001 4:41 pm
by Lasher
I remember in prior versions of ICAD2000 you can press Shift + Right Click and bring up a menu to choose osnap options and the such. But now whenever I do that it rotates the drawing and I find that rather annoying. Also you could hold down the shift and ortho would be temporally turned off. My question is, is there any way to disable this rotating and go back to the menu? Thanks.
Posted: Fri Aug 17, 2001 5:35 pm
by John Finlay
Lasher,
I have just tried these out in CMS Professional ICAD2001.3.8.7 and all is working correctly. There has been some snap/ortho problems in prior 2001 versions.
What version are you using?
------------------
Regards
John Finlay
Don't want to post a question - email me direct on john@acecad.com.au
Posted: Sat Aug 18, 2001 11:43 pm
by Lasher
The freeware that was downloaded off the web-site which probally explains the problems. Thanks anyways.
Posted: Sun Aug 19, 2001 6:22 am
by MTriche
Lasher,
The free demo will be updated next week and you will see many improvements over the version you recently downloaded including the one you mentioned. I will post as soon as it is available.
Melodie
Posted: Sun Sep 30, 2001 8:51 am
by Alosius
I'd like to know if it is possible to change Shift+Right clicking for just middle clicking, I don't like to pan with middle clicking.
Can you help me?
Thank you.
Posted: Sun Sep 30, 2001 2:10 pm
by John Finlay
Alosius,
To change back the Middle Button to display running snaps instead of pan:
type MButtonPan at the command prompt and type Off.
The MButtonPan is the system variable that turns on/off "Middle Button Pan"
------------------
Regards
John Finlay
Don't want to post a question - email me direct on john@acecad.com.au