That is a great site. Thanks for sharing with us. I am sure we can all benefit from your contribution.
Anyone who has not seen this site yet, go check it out there are a few very usefull lisp routines for anyone using IntelliCAD.
------------------
David Trotz
#4
avaernes, Thanks for your reply. There are no solid hatches or pspace viewports. The drawing is a very simple small assembly. The problem appears to occur whenever the drawing is saved as a std r14 dwg, but not when saved as r13 or below.
Thanks
muncie
[This message has been edited by muncie (edited 01-10-2001).]
Thanks
muncie
[This message has been edited by muncie (edited 01-10-2001).]
#5
Hello Munci,
Could you send a sample drawing for me to look at? It may help in determining what is going on. Just note on the email that it is for me.
Melodie
cms@etoolbox.com
Could you send a sample drawing for me to look at? It may help in determining what is going on. Just note on the email that it is for me.
Melodie
cms@etoolbox.com