What is that annoying little symbol next to the curser? Is there any way to get rid of it?. I asked this question on the usenet intellicad forum and no one seemed to know what I was talking about. I can't beleive that I am the only one that finds that it clutters up the drawing area and gets in the way. The thing that I am talking about is the little circle with a line threw it to the lower right of the curser that apears when ever you activate a drawing tool.

CW,

There should be a number of symbols that appear next to the cursor.

These represent snap modes and they match the symbols on the Entity Snaps toolbar.

They were used prior to fly-over snapping and were very usefull - they may have outlived their use.



------------------
Regards
John Finlay