Why is it that when i dimension a short distance say 2" vertically, the dimension tick is opposite in direction to that when i dimension a longer dimension say 10'-0 .Please reply to this e-mail asap.

I also noticed this as well and it only occurs when the dimension distance is small. It leaves the appearance of an "X" instead of a "/" when using continuing dimensions.

I think this occurs when using previous ICAD drawings with an updated version of ICAD.

When I tested new versions of ICAD with new layouts this problem didn't appear.

I would say it may come from settings in the dimensioning conflicting with the openDWG's specs.



------------------
Regards
John Finlay