Has anybody else experienced this problem with the new version 3.3, as i zoom in real close on an object say for instance intersection of two lines, my screen changes color to current layer color filling up the whole screen and then intellicad crashes, anybody got any ideas ? below are details.

ICAD caused a general protection fault
in module DIBENG.DLL at 000c:000019cb.
Registers:
EAX=00ff0000 CS=03f7 EIP=000019cb EFLGS=00010246
EBX=065500a2 SS=35af ESP=cfcd7c0e EBP=f4fa0001
ECX=00000001 DS=3b9f ESI=00000c00 FS=05f7
EDX=55930001 ES=3b9f EDI=090e9400 GS=233e
Bytes at CS:EIP:
f3 ab 03 fe 66 4b 7e 15 66 8b cd 0b d2 78 07 66
Stack dump:
00007cd2 ffff0026 00000000 05510025 02a703cf 02190008 0000e9ba 0000ea3e 00000000 00000000 782000af 000200c6 00000000 377c0000 4a8001fe 000001ff

3.04 does it too but does not crash - you can just zoom back out. The programmers know about it, and some other display problemettes which crept in from 3.04 to 3.3.
Someone might correct me but this is how I think it is: V3.3 has been available as demo/beta for a while but just recently officially released as V3.3, with some fixes but no list of what they are.

I had that same problem yesterday. I dont think we had that problem before on the other version.

Pete

I had no problems with ver 3.1 doing this just the new ver 3.3

I have had this problem since using ICAD 2000 versions. Sometimes it will crash, sometimes not. If the screen does this I usually do a save, exit ICAD, and then restart ICAD.

I am using WIN98se with a Diamond Stealth video card (not the best card).

ssc

Are there drawing or scenario to reproduce the problem?