I would like to ask if anybody know the differnce between Hatch and Boundary Hatch ? Are there any advantages of using hatch instead of Boundary hatch ?

tooldesigner,

The boundary hatch has a boundary around it that will automatically fill with the hatch if altered in any way.

A hatch will not change if the original boundary is altered.

Check this out by drawing a closed rectangle and fill with a boundary hatch. Delete the closed rectangle and select the boundary hatch. Select a handle on one of the corners and move it – notice the hatch change automatically.



------------------
Regards
John Finlay
Don't want to post a question - email me direct on john@acecad.com.au