The following works ok in 6.2, but gives "Run Time Error 5, Invalid procedure call or argument" in 6.4 at the ElemPoints.Add command. Any thoughts?
Thanks,
Erik
-----------------------------------
Sub testPoints()
Dim ElemPoints As IntelliCAD.Points
Set ElemPoints = New IntelliCAD.Points
ElemPoints.RemoveAll
ElemPoints.Add 1, 2, 3
End Sub
Points Collection
#3HI, I am also having this problem as i use a points collection for drawing a hatch pattern . Is there any other way of doing a hatch pattern without using the points collection
evaluatelispexpressin
#5thanks john,
unfortunately i dont know lisp programming, would it be possible for you to post some example coding on how to place a hatch pattern using the EvaluateLispExpression routine.
unfortunately i dont know lisp programming, would it be possible for you to post some example coding on how to place a hatch pattern using the EvaluateLispExpression routine.