The AddPolyline example ojn the, IntelliCAD Help Guide, doesn't run correctly.
Can you give me a corredt example?
Thanks and regards
Andrea
#2
andreadiloreto,
I just tried the example and it works ok.
Try it on a new blank drawing because it only draws a short polyline about 2.8 drawing units long and then zooms to it. If there are other entities on the drawing that are substantially larger you may not see the polyline.
What problems are you having?
------------------
Regards
John Finlay
I just tried the example and it works ok.
Try it on a new blank drawing because it only draws a short polyline about 2.8 drawing units long and then zooms to it. If there are other entities on the drawing that are substantially larger you may not see the polyline.
What problems are you having?
------------------
Regards
John Finlay