In the latest 6.1.19.0 CMS release the toolbars don't remain "stacked" between invocations. Instead of lining up like:

[====][===]
[===][====]

They "unstack" when the program is closed and then re-opened, like:

[====]
[===]
[===]
[====]

Not fatal but it is a pain and nothing that I recall seeing in any earlier release.

Running on WinXP SP2 w/ current MS updates.

This is a pain !
It should be fixed ASAP.

I just checked. Same on mine. I generally don't use enough tool bars to notice so if no one had brought it up, I would have never known.

I never noticed because I run them down the right side, 3 or 4 wide with one row across the top. That makes the screen roughly the best aspect ratio for me. Might not suit everyone but the toolbar fairy doesn't move them around overnight.

I now know the answer to this one. If you change your view of IntelliCAD from full screen to a window you will notice the default installation window size is small. IntelliCAD, when starting, restructures its toolbar layout to fit the window size. Now the answer is simple. Just resize the window to almost full screen size then close the software. This fixes the window size to large. Now re-run IntelliCAD, change to full screen and move your toolbars to suit. Now close IntelliCAD again. From now on IntelliCAD will open full screen with the toolbars where you want them. Simple really

[This message has been edited by geraldpeterrobinson (edited 02-12-2006).]

Great! It works fine. Tank you!

Thank You mr. Peterson