buffer overun

#1
Downloaded Intellicad FV. I opened a drawing that was created using Cadopia 2k saved as a new number. When opening the newly created drawing the following error occurs. "BUFFER OVERUN THIS FILE MAYBE A AUTOCAD R14 BETA FORMAT FILE" then Intellicad bails out. This has occured more than once. Any suggestions thanks.

muncie

#3
avaernes, Thanks for your reply. There are no solid hatches or pspace viewports. The drawing is a very simple small assembly. The problem appears to occur whenever the drawing is saved as a std r14 dwg, but not when saved as r13 or below.
Thanks

muncie

[This message has been edited by muncie (edited 01-10-2001).]