Ver 11.0 ALIASEDIT is not working for me. When I assign a 2-key to a command, it even comes up in the autocomplete window and shows the short key-in and the command but always returns eg. Unable to recognize command "CI" . Please try again.
Any ideas?
Thanks

rhgrafix wrote: ↑

Sun Nov 20, 2022 11:57 pm

Ver 11.0 ALIASEDIT is not working for me. When I assign a 2-key to a command, it even comes up in the autocomplete window and shows the short key-in and the command but always returns eg. Unable to recognize command "CI" . Please try again.
Any ideas?
Thanks

Same for me. Editing Alias does not work. I would not buy the software if I knew custom alias don't work.

The ALIASEDIT works on the 11.1 and 12.0 versions.
After assigning an alias, please restart the IntelliCAD, then try the new one.

QuanNguyen wrote: ↑

Fri Jan 05, 2024 6:16 pm

(...) please restart the IntelliCAD, then try the new one.

That worked. Thank you.

Been fighting this in Intellicad 12.1. Assigned Breakatpoint to BAT, and even after restart the program shows the alias in the popup and gives the error "Unable to recognize command "BAT". Please try again."

Managed to get it to stick for this instance of the program by deleting the offending alias and re-assigning via a new alias.