Hi, I installed and use ver. 11.1.
Earlier when I drew e.g. a line and chose "Settings..." from shift+mouse right click menu, the snap settings window opened up and I could turn on or off any of the snap settings. I used this when I wanted to turn on more than one new snap. For example I could turn on the Endpoint and Midpoint. Now in 11.1 the snap settings window does not open up (during a command when I choose Settings... from shift+mouse right click menu), I can only choose snap options in the command bar, and the worst is that if I choose one snap option there, IntelliCAD turns off all the other snaps permanently. Can previous behaviour be restored somehow? (Maybe I've done something wrong?)
Thanks for any advice.

Check your system variable FILEDIA.
This should be set to 1

Thanks for the idea. I checked that and it is 1 as it should be by default.
So did this problem appear only for me?

In the meantime I did a clear reinstall (I mean without transferring any of my old settings from 11.0) and unfortunately the snap settings window still does not open during command. I hope it will be fixed soon.

It works on my installation (Icad 11.1 PE+): .

Sellecting Settings does open the dialog

SteveN

Hi Steven, does it open during a command? For example when you draw a line? When no command is running the dialog opens for me too.
Zsolt

When drawing a line:
Yes it opens, but when you select 'settings' it defaults to the command line rather than open the settings dialog.

However both 10.1 and 11.0 open the dialog and allow you to make changes.

Seems to be a bug, suggest you send in a feedback form.(in HELP)

SteveN

Hi Steven, thank you for your confirmation. I am going to report this bug because the snap dialog is important during editing.
Zsolt