Forum has been down!

Topics relating to CAD system setup issues for small businesses.

Moderator: CMS Inc

Post Reply
Valued Contributor
Posts: 196
Joined: Sun Jul 30, 2000 11:01 pm

Forum has been down!

Post by MTriche » Tue Jan 15, 2002 3:56 pm

Sorry for the inconvenience of the forum being down for the last 1-1/2 weeks. Someone had emailed to say they were having problems posting and I thought it was because they were not showing up as a registered user. I then took off for vacation for a week and just returned to find a ton of emails claiming that “permission denied” messages were showing up everywhere. The people who set the forum up have just fixed the problem (something with the server) and everyone should be able to post once again.

Again, I apologize for the problem.

Posts: 10
Joined: Fri Feb 01, 2002 12:01 am
Location: USA

Post by drawit » Fri Feb 01, 2002 9:04 pm

Hello friend,

I used Intellicad 98 I believe for a trial run for a short time. It was a very nice introduction to a good product. However it had a nasty problem with an UNDO bug that would go way too far back. Has that been fixed in your new release ?
Please let me know the status cause if it has been fixed I will be ready to tell my friends and I will upgrade eagerly !!

Post Reply