New User Problem with User Coordinate System (UCS)
Posted: Thu Apr 22, 2021 9:20 am
Hi!
When working on an 3D-Model I often have to set a workplane and use that for further building the model.
As I have understood this is implemented in Intellicad with UCS - correct?
But I have a problem using "UCS Entity".
Example: I have a 4-side Pyramid solid and want to use one of the sides as the plane for further building. I try to use "UCS Entity" but when I have to select the entity I always get the message something like "this selection cannot be used for UCS entity". No matter where I select a face of the pyramid the same error comes up.
I am sure I do something wrong but I could not find a away to achieve this result.
Information according to this is very welcome.
Regards
Johannes
When working on an 3D-Model I often have to set a workplane and use that for further building the model.
As I have understood this is implemented in Intellicad with UCS - correct?
But I have a problem using "UCS Entity".
Example: I have a 4-side Pyramid solid and want to use one of the sides as the plane for further building. I try to use "UCS Entity" but when I have to select the entity I always get the message something like "this selection cannot be used for UCS entity". No matter where I select a face of the pyramid the same error comes up.
I am sure I do something wrong but I could not find a away to achieve this result.
Information according to this is very welcome.
Regards
Johannes