Can I have a choice of actions when selecting 'OK'?
Posted: Thu Dec 31, 2020 2:48 am
I am continuing progress with this piping utility:
.
All of the 'fittings' & 'Flanges' are complete and are working.
Up until now every choice resulted in an existing block (dwg) to be inserted into the active drawing.
I have added a new 'selection' item 'pipe' but the action here when selecting 'OK' will be to draw 2 concentric circles, extrude these to create 2 solid cylinders, subtract the smaller from the larger to create a section of pipe.
I have written the lisp to create the pipe, and this works as a stand alone lsp (in ICAD9.0 only??), but I would prefer to integrate this into the main utility.
see here: viewtopic.php?f=2&p=6937&sid=04d33132b5 ... 94fe#p6937
Unfortunately I'm not sure if this is achievable? as my attempts so far have failed
SteveN.
.
All of the 'fittings' & 'Flanges' are complete and are working.
Up until now every choice resulted in an existing block (dwg) to be inserted into the active drawing.
I have added a new 'selection' item 'pipe' but the action here when selecting 'OK' will be to draw 2 concentric circles, extrude these to create 2 solid cylinders, subtract the smaller from the larger to create a section of pipe.
I have written the lisp to create the pipe, and this works as a stand alone lsp (in ICAD9.0 only??), but I would prefer to integrate this into the main utility.
see here: viewtopic.php?f=2&p=6937&sid=04d33132b5 ... 94fe#p6937
Unfortunately I'm not sure if this is achievable? as my attempts so far have failed
SteveN.