I have written a lsp file to create a length of pipe between 2 points, eventually to be incorporated into a larger routine.
It works as exected in Icad 9.0 (9.0.815.0.PE+.VC15.x64.RF90), but in Icad10 (10.0.1108.115690.PE+.VC15.x64.CMS100) the results are wrong!! see below (lisp file attached)
The user is intended to 'pick' the start point of the pipe run (centre of the elbow fitting) and the end point (top end point of vertical line).
Icad 9.0 results.
Is this s bug?