DOSLib for IntelliCAD

Topics relating to AutoLisp and SDS.

Moderators: CMS Inc, avaernes

Post Reply
dooleybob41
Newbie
Posts: 6
Joined: Fri Jun 29, 2018 4:07 pm

DOSLib for IntelliCAD

Post by dooleybob41 » Wed Jul 25, 2018 3:45 pm

I've used DOSLib in my AutoLISP programming for many years, so was excited when I found an older post about DOSLib4 for AutoCAD.

I couldn't find a copy of DOSLib4, so asked Dale Fugier at McNeel about it. He sent me a copy of DOSLib4, but warned that it might not load. It didn't.

I asked him if there was a possibility of a version of DOSLib for 64-bit IntelliCAD, and he said no - too much work for a free tool.
Post Reply