Trim troubles

General topics relating to CMS IntelliCAD.

Moderator: CMS Inc

Post Reply
adamsandiford
Newbie
Posts: 6
Joined: Fri Dec 10, 2004 12:01 am
Location: St. Catherines, Ontario, Canada

Trim troubles

Post by adamsandiford » Fri Dec 10, 2004 1:23 pm

Has anyone else noticed a problem (maybe not a problem, but a change) with how trimming is handled? In CMS5, I've trimmed lines like this:

_|_|_ (trying to trim out the middle line using the uprights as the trim entities). The uprights have a line that goes between them |_| but not past either upright. When I trim, the |_| line is also trimmed out. Is there a fix for this? (I'm sorry it's so hard to make sense of, but I can't get screenshots to work). Please let me know.
Post Reply