Extend doesn't work on ICAD5

General topics relating to CMS IntelliCAD.

Moderator: CMS Inc

Post Reply
lfabiani
Newbie
Posts: 2
Joined: Fri Dec 10, 2004 12:01 am
Location: São Paulo, SP, Brasil
Contact:

Extend doesn't work on ICAD5

Post by lfabiani » Fri Dec 10, 2004 10:22 am

When you draw a circle, and a line starting from outside the circle and ending inside it, when you do a extend comand selecting the circle as the boundary and click on the line, the line gets trimmed to the boudary of the circle... shouldnt it be going to the oposite boudary, and crossing the circle?
Post Reply