Preview pane

General topics relating to CMS IntelliCAD.

Moderator: CMS Inc

Post Reply
CW
Valued Contributor
Posts: 122
Joined: Wed Sep 10, 2003 11:01 pm

Preview pane

Post by CW » Tue Apr 13, 2004 11:45 am

If I make a block and save it, when I go to insert it, it often doesn't show right in the preview pane. It will often be too small or to large. This, despite zooming it to extents before saving. Is there some way to make these thisngs look right?

[This message has been edited by CW (edited 04-13-2004).]
Post Reply