Page 1 of 1

buffer overun

Posted: Tue Jan 09, 2001 11:18 am
by muncie
Downloaded Intellicad FV. I opened a drawing that was created using Cadopia 2k saved as a new number. When opening the newly created drawing the following error occurs. "BUFFER OVERUN THIS FILE MAYBE A AUTOCAD R14 BETA FORMAT FILE" then Intellicad bails out. This has occured more than once. Any suggestions thanks.


Posted: Tue Jan 09, 2001 4:47 pm
by avaernes
Do the drawings contain solid hatching or pspace viewports?

Posted: Wed Jan 10, 2001 5:07 am
by muncie
avaernes, Thanks for your reply. There are no solid hatches or pspace viewports. The drawing is a very simple small assembly. The problem appears to occur whenever the drawing is saved as a std r14 dwg, but not when saved as r13 or below.


[This message has been edited by muncie (edited 01-10-2001).]

Posted: Wed Jan 10, 2001 10:26 pm
by MTriche
Hello Munci,

Could you send a sample drawing for me to look at? It may help in determining what is going on. Just note on the email that it is for me.