Page 1 of 1
spline
Posted: Thu Oct 16, 2003 12:59 am
by rolando
i cannot trim a spline.what is the command?
Posted: Thu Oct 16, 2003 8:12 am
by ssc
I do not believe that splines can be trimmed.
One is supposed to be able to extend to splines, however, I have not been able to do this either.
ssc
Posted: Thu Oct 16, 2003 10:13 pm
by CW
I ran into this yesterday. No, splines can not be trimed. My solution was to go back to using Turbocad.
Posted: Fri Oct 17, 2003 1:57 am
by avaernes
Spline-fit polylines can be trimmed.
Posted: Fri Oct 17, 2003 7:45 am
by ssc
avaernes is correct, you can use a spline-fit polyline. However, these are not true splines, you have to change the number of points for curved sections to approximate the curve.
ssc
[This message has been edited by ssc (edited 10-17-2003).]
True ellipses are similar in nature. They can be trimmed, however, they cannot be used as the extend to boundary.
[This message has been edited by ssc (edited 10-17-2003).]