That is a great site. Thanks for sharing with us. I am sure we can all benefit from your contribution.

Anyone who has not seen this site yet, go check it out there are a few very usefull lisp routines for anyone using IntelliCAD.

David Trotz

avaernes, Thanks for your reply. There are no solid hatches or pspace viewports. The drawing is a very simple small assembly. The problem appears to occur whenever the drawing is saved as a std r14 dwg, but not when saved as r13 or below.


[This message has been edited by muncie (edited 01-10-2001).]


I have the same Problems like you. But I noticed that the error occurs even with acad2000.dwg. And the error occurs not every time when you save the drawing. Maybe it belongs to the autosave-function???