Page 1 of 1
Issue with printing
Posted: Sun Apr 18, 2021 5:41 am
by sohkimlon
I am using Version 9 purchased in August 2020. I have not been able to print with a physical printer. It always print to a PLT file that I could not open. I was allowed to choose a physical printer but the end result is that it always print to a PLT file. I need to print to a pdf file first. I then open this pdf file with a pdf reader and print from there. I would then have problem with the resolution with this method.
Is that a setting problem or a bug ?
Hope to get this settled urgently.
Re: Issue with printing
Posted: Sun Apr 18, 2021 5:43 am
by sohkimlon
sohkimlon wrote: ↑Sun Apr 18, 2021 5:41 am
I am using Version 9 purchased in August 2020. I have not been able to print with a physical printer. It always print to a PLT file that I could not open. I was allowed to choose a physical printer but the end result is that it always print to a PLT file. I need to print to a pdf file first. I then open this pdf file with a pdf reader and print from there. I would then have problem with the resolution with this method.
Is that a setting problem or a bug ?
Hope to get this settled urgently.
P/S : I am considering purchasing DWGSee just to print my drawings.
Re: Issue with printing
Posted: Sun Apr 18, 2021 6:21 pm
by QuanNguyen
Can you try to uninstall and reboot before re-install the IntelliCAD.
Re: Issue with printing
Posted: Mon Apr 19, 2021 12:13 am
by sln8458
Hi,
Just a thought, but have you 'ticked' the print to file' box?
Located in the print dialogue, just to the left of my highlighted printer below (Foxit Reader....)
- printToFile.jpg (130.31 KiB) Viewed 2939 times
Steve
Re: Issue with printing
Posted: Tue Apr 20, 2021 10:10 am
by sohkimlon
I have reinstalled. It is okay now. Thank you.