compatible files

General topics relating to CMS IntelliCAD.

Moderator: CMS Inc

Post Reply
rolando
Newbie
Posts: 9
Joined: Sun Jul 28, 2002 11:01 pm
Location: the Philippines
Contact:

compatible files

Post by rolando » Mon Jul 29, 2002 5:05 am

can intellicad support files from microstation or microcad?
MTriche
Valued Contributor
Posts: 196
Joined: Sun Jul 30, 2000 11:01 pm

Post by MTriche » Thu Aug 01, 2002 11:55 pm

I've never tried it but would think if you dxf'd it out that it should not be a problem. Give it a try it with the trial version.

Melodie
jgaunt
Contributor
Posts: 10
Joined: Wed Jun 26, 2002 11:01 pm
Location: Australia

Post by jgaunt » Fri Aug 02, 2002 6:39 am

Maybe it's not politically correct here, but Turbocad can open dgn files - then save as dwg. I think Icad is a better program but Tcad can be useful if just to open/save in different formats.
Post Reply